D3-CMD2-T

2 RELAYS

This device is used to display and monitor DC current.
The 50mV DC input signal is displayed as the current through the shunt with up to 3 decimal places.
Maximum & Minimum values are logged for 24 hours (updated every 60 min).
The relay may be used for over and / or under protection.
The latch facility may be de-activated for one or both the relays allowing one relay to be used for control (not latched), and the other as a latched alarm.
Use the “ScAL” parameter for calibration purposes, or to change the number of decimal places displayed.
Other features include adjust able signal damping, adjustable start-up and reaction delays, the ability to swap the relay’s functionality.
All settings may be locked & code protected to avoid changes from being made by unauthorised personnel.

ADDITIONAL FEATURES INCLUDE:

• adjustable scale & resolution
• adjustable HYSTERESIS (DIFFERENTIAL)
• START-UP DELAY allows the current to stabalize at startup before monitoring starts
• REACTION DELAY prevent tripping for a pre-set time period
• LATCH facility to force manual reset after fault
• LATCH can be enabled / disabled for each relay independantly (used when one relay is alarm relay)
• independantly invert relay action, ie close while in fault condition
• keypad lock with code

ADJUSTABLE PARAMETERS:

SCALE : 1A - 9999A

DECIMAL POINTER : 0.000 / 0.00 / 0.0 / 0

UPPER LIMIT : 1A - full scale

LOWER LIMIT : 1A - full scale

HYSTERESIS: 1A - full scale

START-UP DELAY: 0 - 99 seconds

REACTION DELAY (TRIPP DELAY): 0 - 99 seconds

CALIBRATION: 90% - 110%

RESPONSE TIME :<1-4 sec

Specifications:

Display scale:                   10 to 9999

Display resolution:           0.01 to 1.000  (adjustable)

Measurement resolution:  50 uV

Accuracy:                          ±0.3% @ 25°C (% of full scale)

Input voltage:                   ±15% of rated input

User Manual